New fence installation in Centennial is a site-planning project before it is a material order. A useful proposal identifies the legal parcel, street and trail edges, easements, buried utilities, grade, drainage, gates, existing improvements, and every approval that controls the visible result. Apollo Construction uses that record to describe a planning range and a buildable sequence rather than treating a drawing of a rectangle as a completed design.
This guide is for project planning, not a substitute for an address-specific decision by the responsible authority, a survey, engineered design, or association approval. Requirements change with the zoning district, plat, prior approvals, floodplain or drainage condition, utility corridors, and the way a corner lot faces the street. We verify those details before scheduling removal or ordering custom panels.
Centennial Requires a Fence Permit for New Fences
The City of Centennial requires a fence permit for every new fence and for replacement work that changes height, location, or material. The application calls for a site plan or survey and a fence or wall diagram that identifies the proposed height, material, and color. City of Centennial, Apply for a Fence Permit is the issuing authority used for this project checkpoint.
Centennial Sets Four-Foot Front-Yard and Eight-Foot Side-and-Rear Limits
Centennial Land Development Code Section 12-3-602 lists a four-foot maximum in the front yard and eight feet in interior-side, street-side, and rear yards for standard residential fences, subject to the Code’s other requirements. City of Centennial, Apply for a Fence Permit is the issuing authority used for this project checkpoint.
Centennial Has Different Street-Side Rules for Corner Lots
Section 12-3-602 treats the street-side yard separately from the interior side yard. On a corner parcel, the street-side location can be at the property line only with the published sidewalk or street clearances, and it remains subject to Section 12-11-208 sight-triangle rules. City of Centennial, Apply for a Fence Permit is the issuing authority used for this project checkpoint.
Centennial Requires a Clear Public-Edge Offset
The City’s standard residential table requires at least six inches from a sidewalk where present and five feet from streets where no sidewalk exists for the front, street-side, and rear conditions described in the table. We measure the actual public edge rather than relying on a landscape line. City of Centennial, Apply for a Fence Permit is the issuing authority used for this project checkpoint.
Centennial Inspects Taller Fences After Completion
Centennial’s permit guidance calls for a completion inspection for fences over six feet, while fences six feet or lower do not require that inspection. The permit requirement itself still applies to every new fence. City of Centennial, Apply for a Fence Permit is the issuing authority used for this project checkpoint.
Centennial HOA Approval Can Still Control the Design
Centennial’s public approval is not an HOA approval. In neighborhoods governed by covenants, a more restrictive association rule on material, color, style, or height governs and must be resolved before ordering. City of Centennial, Apply for a Fence Permit is the issuing authority used for this project checkpoint.
Fence Work Near Centennial
Apollo Construction plans privacy fences, open metal and picket fences, wood and composite systems, gate replacements, screen walls where allowed, and fence coordination with patios, decks, sheds, grading, and exterior remodels. The design starts with its job: securing a yard, defining a dog area, screening equipment, enclosing a permitted pool, or closing a gap left by a larger project. Each purpose creates different clearance, material, gate, and review questions.
Site review, boundaries, and approvals
We measure the planned alignment, photograph existing conditions, identify drives, walks, overhead lines, drainage paths, retaining edges, irrigation, landscaping, and points where the fence meets a house or other structure. The record separates what is known from what needs confirmation. A county assessor map, a neighbor’s fence, or a contractor’s tape measure may help planning, but it does not replace the survey evidence needed where a property line is disputed or uncertain.
Public permits, zoning clearance, building-code barriers, historic or design review, and association approval are different decisions. A municipal approval does not authorize a covenant violation; an association approval does not authorize work in an easement or right-of-way. Before procurement, the project record identifies the owner, address, proposed materials and height, authority, approval holder, documents needed, and any unresolved condition.
Utilities, easements, drainage, and soil
Colorado 811 must be contacted before excavation so member utilities can mark their facilities. The locate ticket does not locate every private service: irrigation, low-voltage lighting, private gas lines, drainage piping, pet-containment wire, and owner-installed utilities still need to be identified. Posts are not set on the assumption that an unmarked line is absent.
Easements remain access corridors even if they look like backyard. Drainage swales, inlets, ditches, trails, and open-space edges need to continue functioning after the work. We avoid blocking sheet flow, trapping water against a fence, or installing a continuous solid barrier where maintenance access or stormwater conveyance needs a different detail. On Front Range sites, expansive clay and variable fill make moisture control and uniform support important; visible heave, settlement, slope, or persistent wet soil can justify further design direction.
Materials, posts, gates, and closeout
Material is selected for the approved location, desired privacy, maintenance tolerance, wind exposure, fire or design constraints where applicable, and the way the fence must meet grade. Posts and rails are installed to the selected system and verified layout; gates receive enough room to swing, latch, drain, and remain adjustable as seasons and soils change. We do not promise that any material is maintenance-free or that a rigid fence line will hide a changing grade.
Planning ranges account for measured length, height, material, demolition and disposal, access, gates, corner and slope work, post conditions, utility coordination, permits, approvals, and restoration. They are estimates, not quotes, until the address, authority requirements, utility marking, boundary evidence, and site conditions are established. If a concealed utility, easement requirement, unsuitable soil, or reviewer direction changes the work, we document it and explain the planning effect before proceeding.
Before field work begins, staging, removal routes, protection for planting and hardscape, daily access, and the sequence for a temporary opening are agreed. A gate opening, pet enclosure, shared drive, or narrow side yard can control the order of work as much as the selected material.
Removal is staged to keep the site safe and serviceable. Existing panels, concrete footings, and vegetation are identified in the planning scope, while adjacent finishes that are not part of the work are protected and documented before equipment enters the yard.
At closeout, the scope includes cleanup within the agreed limits, a review of gate operation and visible alignment, and a record of any approval condition that continues after installation. Maintenance begins with keeping drainage paths clear and watching for soil movement at posts and gates.
Wind exposure, grade changes, and the transition between different fence runs are resolved before fabrication. That avoids improvised filler panels, gate conflicts, and a change in visual treatment at the most public part of the yard.
If a project condition changes after removal, we pause at the affected area, document what was found, and explain the available correction before continuing. That approach keeps unknown conditions from being presented as though they were included in the original visible scope.
Fencing in Other Front Range Cities
Apollo handles fencing across the Front Range. Each city page below covers that city’s own permit office, code edition and local conditions.
- Fencing in Arvada
- Fencing in Aurora
- Fencing in Boulder
- Fencing in Castle Rock
- Fencing in Denver
- Fencing in Englewood
- Fencing in Highlands Ranch
- Fencing in Lakewood
- Fencing in Littleton
- Fencing in Parker
- Fencing in Thornton
- Fencing in Westminster
- Fencing in Colorado Springs
- Fencing in Longmont
- Fencing in Golden
- Fencing in Wheat Ridge
- Fencing in Lone Tree
- Fencing in Erie
- Fencing in Castle Pines
- Fencing in Lafayette
- Fencing in Louisville
- Fencing in Greenwood Village
- Fencing in Commerce City
- Fencing in Northglenn
- Fencing in Superior
- Fencing in Evergreen
- Fencing in Ken Caryl
- Fencing in Cherry Hills Village
- Fencing in Monument
- Fencing in Federal Heights
- Fencing in Sheridan
- Fencing in Edgewater
- Fencing in Morrison
- Fencing in Columbine Valley
- Fencing in Manitou Springs
- Fencing in Glendale
- Fencing in Elizabeth
- Fencing in Idaho Springs
- Fencing in Black Forest
- Fencing in Falcon & Peyton
- Fencing in Franktown
- Fencing in Georgetown
- Fencing in Empire
- Fencing in Palmer Lake
- Fencing in Larkspur
- Fencing in Foxfield
- Fencing in Sedalia
- Fencing in Byers
- Fencing in Black Hawk
- Fencing in Central City
- Fencing in Rollinsville
- Fencing in Cripple Creek
- Fencing in Victor
- Fencing in Broomfield
Other Apollo Services in Centennial
Apollo runs every trade below in Centennial with its own crews and its own permit handling, so a project that crosses trades stays with one contractor.
- Kitchen Remodeling in Centennial — layout, cabinetry, counters, plumbing and electrical coordination
- Bathroom Remodeling in Centennial — showers, tubs, vanities, tile and waterproofing
- Basement Finishing in Centennial — egress, framing, insulation, permits and finish work
- Home Additions in Centennial — room additions, bump-outs, structural and permit planning
- Roofing in Centennial — replacement, repair, storm damage and ventilation
- Siding in Centennial — fiber cement, LP and vinyl siding, full re-side
- Concrete in Centennial — driveways, patios, walkways, flatwork and repair
- Deck Building in Centennial — wood and composite decks, railings and permits
- Framing in Centennial — structural framing, walls, load-bearing changes
- Drywall in Centennial — hang, tape, texture, repair and patching
- Painting in Centennial — interior and exterior, prep and finish work
- Tile Work in Centennial — floors, showers, backsplashes, waterproofing
- Demolition in Centennial — selective interior demo and full teardowns
Related Pages
Common Questions
Do I need a fence permit in Centennial?
It depends on the authority, height, location, materials, historic status, and whether the scope includes a retaining wall, pool barrier, public space, or other regulated work. The local facts above provide the published starting point. We confirm the address and scope with the responsible authority before presenting a project as exempt or permit-ready.
Can a new fence sit on the property line?
Only reliable boundary evidence and the applicable rules can answer that for a specific parcel. A recorded easement, public right-of-way, setback, neighbor agreement, or maintenance need may change the practical location. We do not rely on an existing fence as proof of ownership.
What should happen before the post holes are dug?
Confirm the layout and approvals, contact Colorado 811, identify private lines, review easements and drainage, and protect nearby improvements. This sequence is usually less expensive than relocating a newly installed fence after a conflict is discovered.
Does an HOA approval replace City or County requirements?
No. HOA covenants and public rules are separate. When both apply, the project must satisfy both, and the stricter applicable requirement governs the final design.
How is a fence estimate prepared?
We use field dimensions, material and height, removal, access, gates, grade, post conditions, utility and easement questions, public requirements, and approval assumptions to create a planning range. It becomes more precise as the site and authority review are resolved.
Talk to Us About Your Project
Tell Apollo Construction the address, the fence purpose, approximate runs and gates, current material, desired material, and any known HOA, utility, drainage, or boundary issue. Photos showing the street corner, yard edges, existing gates, grade changes, and adjacent trails or sidewalks help us identify the questions that need to be answered before construction.
Our goal is a fence that fits the parcel and its approvals, not a quick installation that transfers a boundary, drainage, or access problem to the owner. We will outline the investigation and assumptions behind a responsible planning range.
Ready to price this service?
Start with our quick estimate. Share the site information you have, and Apollo Construction will turn it into a scoped planning conversation for new fence installation in Centennial.